Hello everyone, I wrote two home decoration reports before. Everyone was more interested in the new style. So this one is a bit simpler, mainly to write about the new style. By the way, introduce the projection of the living room.
I have more than 90 rooms in this suite, located in Tianjin, with heavy pollution. The family planning to start a new style is also relatively opposed, but in the end it decided to pay for it.
The new style uses Honeywell's ern250+fc400 electronic purification, the total cost of 14,000 yuan.
With regard to Honeywell's system, the above article can be referred to in the station. In fact, I also referred to these articles and some other brand articles before selection. In fact, we don't have to think too much about the brand. Everyone has nothing too special about the technology. It's nothing more than thin and thick. Considering that there are few electronic purification brands and the Honeywell factory is in Tianjin, heat exchangers and purifiers are used. Honeywell. In the aspect of type selection, we should pay more attention to the construction party's calculation ability, qualification, size of the machine, after-sales service, etc. After all, the new style is already very mature technology. It has been used in the construction field for a long time, and it has become a business development in the field of civil use. For manufacturers, it is the same as selling three cars before selling cars.
This is a plan that the manufacturer gave me. There is no name here. I can only say that this scheme is really ugly. And faced with three edging, many cross, hit many holes. At that time, I wanted to go straight to another construction. However, afterwards, the manufacturers were able to induce profits. I can only design my own.
This is a self-designed walk-in drawing. The blue line is the new wind. The red line is the return air. Using the entrance, the ceiling of the restaurant hides most of the pipelines. The new air duct in the left living room walks from the ceiling of the air-conditioning duct and the master bedroom on the right side. And the return tube of the second bedroom is the only side that wraps up.
In fact, there is really no technical content in optimizing pipelines. However, when they are equipped, they still have to use their brains, or let the construction personnel use their brains. After all, drilling the ceiling is not a change. It is important to consider clearly and use the best solution.
This is my old house that is also considered to be ten years old. The management team basically belongs to the level of “having trouble and not bothering meâ€. When I went to the property consultancy, the attitude of the property when hitting the beam was casual. Don't tell me, I don’t Check, don't smash the bearing wall. At that time, I was also very aggressive. Because there are two beams from the restaurant and the entrance area, it's quite uneasy.
Later, I took a look at the design school's classmates. Using a detector to detect which steel bars, when drilling a hole to avoid the steel, and finally only hit the two structural bars, without harm.
With regard to drilling and steel reinforcement, please make sure to make related consultations and make arrangements for tenants upstairs and downstairs. If you are complained, you may be fined 20,000 for a start. Don't believe steel reinforcement and carbon fiber reinforcement will have no effect at all. If you can't drill across the beam, consider cross-beam flat tubes
If this doesn't solve the problem, then you can only consider giving it a blow.
This is the effect after the installation. The return duct of the restaurant, in the upper right corner of the picture, can take away the taste of eating.
In the second bedroom, the air outlet was a wall type, and the roof was not lifted.
In the master bedroom, the return air duct has a side, which has little effect on the roof height and sense of space.
Here to pay attention to a few points, first of all, this is my ern250 host, there are several small models behind this host, the air volume is different, of course, the price is different, please be sure to carefully check the data when buying. link
Honeywell official website tour detailed dimensions and parameters. Please check it yourself. It is advisable for the construction company to provide the calculation data of the type selection, such as the ventilation rate, etc. If you have the ability to calculate it yourself, avoid the large machines on the small house causing waste.
Nothing can be said about the fc400, pay attention to the switch after the installation of the linkage (I'm really sloppy construction of this, or when I checked myself)
Borrow a picture of Taobao, this machine can install activated carbon filter, the manual has a cargo number. If the official does not provide a search for xbao, more than 100 pieces will be one. It helps to reduce the smell of ozone.
Regarding the air quality sensor, I did not install it because the feeling is basically on 24 hours. In fact, this air quality sensor is not very useful, and it is not clear where it fits.
In fact this is a 0-10v analog output, I intend to go back and forth, use the PM2.5 sensor (Climbing, a hundred or twenty) 4 ~ 20ma then the transmitter into 0 ~ 10v and then re-calibrate Just connect yourself. The unit price of this air quality sensor is more than 1,500, meaning little.
Now the machine comes standard with the vec8675, 86 box size, much smaller than the previous old control panel such as the 68 series, it is necessary to pull 5 control lines to the new air host in advance, the key touch, backlit white, look quite Western style . Do not talk to the building next to the Tucao. This story has another story. Also do not Tucao wire duct next to the line control, this thing has another story.
It is important to note that the 8675 is also available in 2 models. If there is a subsequent air quality sensor, it must be selected wp20. The controller manual should be well kept. Many parameters need to read the manual to know how to set.
To sum up, after the fresh air is installed, the house's PM2.5 is stable at around 10, and the furniture is also clean on the ground. It will not be clay on hand, and investing in this equipment is still worthwhile.
For the installation process, there are the following suggestions: can be resolved at the design stage, never to the installation and then resolved, the design stage should be to the pipeline, pipe diameter, lintel method, adjustable, pipeline cross, where is the hose Where is the hard pipe, ceiling height and other factors are considered comprehensive, the construction party must be strict requirements, provide a detailed list of materials, construction programs, data calculation, etc., the new style is still very particular, not just pull a team to deal with the end , Try to do a good job in the opposite corner of the room ventilation, wind pressure adjustment must do a good job, or the system is abolished.
Let's talk about projection.
Considering that EPSON adhered to the 3LCD camp and Benki Otto Marnison played three games, I decided to stand on one side and chose tw5210. The 5 series machines have 5200, 5210 and 5300 options. If I remember correctly, 5210 should be It was the 5300 that went wireless. At that time, the purchase price was 4900. Now it seems that it has gone up a bit. The hanger is the B200 of the United States, this has not been installed, so it is a bit ugly, just installed the machine.
In general, the machine is nothing to dry, a lot of sun drying station EPSON, you can refer to the price to select a suitable, if you are not sure whether the dlp or 3lcd, you can go to the store to look at, in fact, less than 10,000 yuan difference in the machine The series of dear friends in the station is well written and worthy of reference. You can learn about it.
In general, the sharpness of the brightness is still acceptable, if you plan to install a projector before the renovation, we must leave a good power plug, to pre-embed a good line, the best hdmi line directly to the decoration team to wear well, and the other in the tube Leaving a pull line, taking into account the hdmi version of a change in a few years, leaving room for future upgrades.
This machine is more expensive 3D glasses, the original one to 300 degrees. Taking into account the current 3D source is not too easy to find, it did not buy.
At the top left corner of the screen, a fresh air tuyere appears.
The screen uses a picture frame curtain, because there is no intention to put a television, so it does not use electric lift. In fact, if you don't put TV, the screen won't fold up and you don't know what to put behind it. Screen size calculations are available on EPSON's official website. Or there is no problem if you hang the machine and buy the curtain. This screen 1300 is difficult to assemble. Only when the L-shaped fixed iron sheet is punched, the burrs are too severe. However, the price of this curtain, it means this, do it yourself, full of food and clothing. In terms of improving the sense of well-being, the total cost will be 6,000 yuan, plus a million yuan or less. This is a 106-inch picture, and television is not comparable.
Then the report of this issue is here, the specific use of the projector, the signal source, wifi, nas, as well as the story of the building intercom and wind pipe machine, see the next set.
Duplex Triplex Quadruplex Service Drop ABC Cable/ Aerial Bundled Cable
VOLTAGE: 600/1000V
CONDUCTOR: Hard Drawn Circular Stranded Aluminium
INSULATION:XLPE compound, X-90 Black
APPLICATION:
Aerial Bundled Conductors XLPE insulated ABC cables have Aluminum Duplex Aerial Bundled cable and Aluminum Triple Aerial Bundled cable.
Aerial Bundled Cable,Medium Voltage Aerial Bundled Cable,Low Voltage Aerial Bundled Cable,Overhead Aerial Cable
Shenzhen Bendakang Cables Holding Co., Ltd , https://www.bdkcables.com